High Gloss Industrial Enamel Surface Coating

Industrial Enamel is a modified single pack urethane enamel made in a high gloss finish. It can be applied to a variety of surfaces including Concrete, Timber and Metal Surfaces that have been primed with a suitable Metal Primer. Industrial Enamel is for interior use only.

Features

Industrial Enamel has excellent durability for a single pack coating. It has very good corrosive and abrasive properties. It is hard-wearing when cured and has excellent Gloss and Colour retention.

Preparation

All surfaces must be free from Rust, Oil, Grease, and all other surface contamination. Bare concrete should be acid etched to increase surface porosity.

Application

Brush, roller, spray. Stir thoroughly before use. Use a good quality brush and a good quality solvent resistant sleeve. Spray application will depend on the type of finish required.

Thinning

For spray application thin 10% – 15% Mineral Turps. Do not thin for brush or roll applications. For bare concrete thin the first coat by 20% – 25% using Mineral Turps.

Drying and Recoating

Industrial Enamel will be touch dry after 25mins (at 25°C) and can be recoated within 4 hours or after 24 hours.

This article comes from nutechpaint edit released

EPiC Industrial Enamel

High Gloss Enamel Surface Coating

Industrial Enamel is a modified single pack urethane enamel made in a high gloss finish. It can be applied to a variety of surfaces including Concrete, Timber and Metal Surfaces that have been primed with a suitable Metal Primer. EPiC Industrial Enamel is for interior use only.

Features

EPiC Industrial Enamel has excellent durability for a single pack coating. It has very good corrosive and abrasive properties. It is hard wearing when cured and has excellent Gloss and Colour retention.

Suitable Substrates

  • Concrete
  • Stainless Steel
  • Blasted Steel
  • Mild Steel
  • Aluminium
  • Galvanised Iron
  • Timber

This article comes from nutechpaint edit released